Concrete for Weaverville, the Reems Creek valley, and the ridges above them. Ten miles north of Asheville, we work both sides of this town: tight old-town lots where access is the problem, and new ridge builds where the builder left the grade for someone else to solve.
Tell us about your Weaverville project and we will get back to you, usually same day or next. Your written quote separates site work from the slab, so you can see what Weaverville ground is actually costing you.
Weaverville is ten miles north of Asheville and has spent the last two decades absorbing the growth that Asheville's own land constraints pushed outward. That shows up in our work as a sharp split between two kinds of job on the same day.
In the older town grid the lots are modest and reasonably level, the houses are early to mid century, and the concrete we are replacing is narrow, thin, and unreinforced. Out in the Reems Creek and Ox Creek valleys and on the ridges above them, it is a different job entirely: newer houses on cut-and-fill lots where the builder graded a pad, got a certificate of occupancy, and left the driveway and the yard for somebody else to solve later.
Those ridge lots are where most of our retaining wall work in Weaverville comes from. A pad cut into a slope leaves a bank above and fill below, and both of them need holding before a driveway poured across them will stay flat.
New driveways on recently built houses are the single most common request, followed closely by retaining walls to make those same lots usable. We also see a steady run of garage and shop slabs, because the acreage out toward Ox Creek supports outbuildings in a way that an Asheville town lot does not. Downtown Weaverville generates smaller replacement work, walks and steps and short drives, on a scale where getting a truck in without damaging the neighbour's yard is half the planning.
Most Weaverville driveway calls come from houses built in the last twenty years on cut-and-fill pads above Reems Creek. The failure mode is always the same — fill that was pushed level rather than compacted in lifts, telegraphing through the slab in the second or third winter. We compact in lifts and thicken the edges over the fill side.
Ridge lots north of Asheville almost all need a wall before anything else works. Cutting a house pad into a slope leaves a bank above and fill below, and both want holding. We build poured and segmental block walls here with drainage engineered in, because the deep valley soil that makes this area green also holds water against a wall.
The acreage out toward Ox Creek supports outbuildings that an Asheville town lot never could, so shop slabs, barn floors, and equipment pads are a real part of our Weaverville work. Those go in at five to six inches with reinforcement sized to what will actually park on them.
Whether you're up a Reems Creek Road driveway, out toward Ox Creek on acreage, or on a tight lot in the old town grid, we'll come measure your Weaverville project and give you an honest written quote at no cost.
The valleys north of Asheville have deeper soil than the slopes around them, which sounds like good news and often is not. Deep soil on a grade is exactly the material that creeps, and a driveway poured on uncompacted fill in the Reems Creek valley will telegraph that movement within two or three winters. On the ridges the opposite problem shows up: weathered rock close enough to the surface that excavation cost jumps mid-job if nobody checked first. At 2,152 feet Weaverville sits marginally higher than Asheville and cycles through the same hard freeze-thaw, so air entrainment and joint discipline are not optional on any exterior pour up here.
Getting to you: US 19/23 and Reems Creek Road are our usual routes in, and we regularly work the Reems Creek valley, Ox Creek, and Stoney Knob areas. Permits run through the Town of Weaverville for work inside town, and Buncombe County Permits and Inspections for the Reems Creek and Ox Creek addresses outside it.
No obligation, no pressure. Tell us what you are planning and we will come look at the ground it has to sit on.
As a newer business we are in the process of collecting reviews. We would be honored to earn your Weaverville project and your feedback.
As a newer business we are in the process of collecting reviews — new reviews coming soon.
As a newer business we are in the process of collecting reviews — new reviews coming soon.
As a newer business we are in the process of collecting reviews — new reviews coming soon.
Straight answers about concrete work in Weaverville and Buncombe County. If your question is not here, send it through the estimate form and we will answer it.
The Asheville Concrete Company is a locally owned and operated concrete contractor serving Weaverville and the rest of Buncombe County from a base in Asheville. The company is licensed and insured, and every project starts with a free, no-obligation on-site assessment and a written estimate. Work in Weaverville covers concrete driveways, stamped patios, sidewalks and walkways, retaining walls, pool decks, RV and equipment pads, slabs, dumpster pads, and commercial flatwork. What sets the work apart here is that it is priced for Weaverville conditions specifically: a small town absorbing Asheville's growth onto its surrounding ridges, at about 2,152 feet, roughly 10 miles north of Asheville.
That depends on the work and on where the property sits. Permits in Weaverville go through the Town of Weaverville for work inside town, and Buncombe County Permits and Inspections for the Reems Creek and Ox Creek addresses outside it. Flatwork poured at grade, such as a driveway, patio, or walkway, often does not require a building permit. Retaining walls are the usual exception: once a wall retains more than four feet of unbalanced fill it generally requires a permit and an engineered design under the North Carolina Residential Code. We confirm the requirement for your specific address before any work begins rather than assuming it based on the last job we did nearby.
Yes. Weaverville is about 10 miles north of our Asheville base and sits inside our standard service territory, so there is no travel surcharge. We work throughout Buncombe County and regularly run jobs in Mars Hill, Biltmore Forest, Marshall, Swannanoa, Candler, Arden, Black Mountain, Fletcher. Estimates in Weaverville are free and carry no obligation. If your address sits near the edge of the county we will tell you plainly whether we can get to you rather than quoting and backing out.
Two very different conditions inside the same ZIP code. Deep valley soil along Reems Creek creeps under load if it was not compacted in lifts, while the ridge lots above hit weathered rock shallow enough to change an excavation price mid-dig. We check both before we quote, because guessing wrong in either direction is expensive.
A standard broom-finished concrete driveway generally runs $8 to $15 per square foot installed, and stamped or decorative finishes run $14 to $22 per square foot, so a typical 600 square foot two-car driveway lands between roughly $5,000 and $9,000. What moves that number in Weaverville is site work rather than the concrete itself. We price excavation, grading, drainage, and removal of old concrete as separate visible line items so you can see what the site is costing you as distinct from the slab.
Foot traffic after 24 to 48 hours, passenger vehicles after 7 days, and anything heavy such as an RV or a loaded trailer after a full 28 days. Concrete reaches about 70 percent of its strength in the first week and keeps curing for roughly a month. At 2,152 feet, Weaverville runs colder than the Piedmont, so late-season pours cure more slowly and we schedule around the forecast and protect the slab rather than pushing the timeline.
We also work these communities around Weaverville. Not sure whether your address is covered? Send it over and we will confirm before you spend time on it.
Or head back to our concrete company in Asheville for the full service list and pricing.